Losi 5ive Forum  

Go Back   Losi5iveForum > Losi 5ive Forum > Losi 5ive Engine & Exhaust

head gasket and porting

Discussion in Losi 5ive Engine & Exhaust forum, started by 5iveguy.

Reply
 
Thread Tools Display Modes
  #1  
Old 05-16-2012, 02:59 PM
5iveguy 5iveguy is offline
Member
 
Join Date: May 2012
Location: old bridge NJ
Posts: 95
Default head gasket and porting

well since i have to replace my head gasket i was thinking about doing some lite porting and polishing on the case and the transition to the head. any pointers out there i would like to hear them i did find the one post in the baja fourm lots of great info but just putting the feelers out...

Reply With Quote
  #2  
Old 05-17-2012, 02:32 PM
5iveguy 5iveguy is offline
Member
 
Join Date: May 2012
Location: old bridge NJ
Posts: 95
Default

i have to say just cleaning the crank case really wakes up the motor if i only knew what i was doing i would play with the timing. the motor has loss most of the bog from a dead stop and now i can make the rear end wash out a whole lot easier thru the turn.
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 08:07 AM.
Maintenance by RCNitroTalk


Powered by vBulletin®
Copyright ©2000 - 2014, vBulletin Solutions, Inc.